May 2016 updated: cisco exam 200-120

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-120 Exam Dumps (PDF & VCE):
Available on:

Actual of 200-120 exam topics materials and tutorials for Cisco certification for IT specialist, Real Success Guaranteed with Updated 200-120 pdf dumps vce Materials. 100% PASS CCNA Cisco Certified Network Associate CCNA (803) exam Today!

2016 May 200-120 Study Guide Questions:

Q211. - (Topic 7) 


Refer to the topology. Your company has decided to connect the main office with three other remote branch offices using point-to-point serial links. 

You are required to troubleshoot and resolve OSPF neighbor adjacency issues between the main office and the routers located in the remote branch offices. 

An OSPF neighbor adjacency is not formed between R3 in the main office and R6 in the Branch3 office. What is causing the problem? 

A. There is an area ID mismatch. 

B. There is a PPP authentication issue; the username is not configured on R3 and R6. 

C. There is an OSPF hello and dead interval mismatch. 

D. The R3 router ID is configured on R6. 

Answer: D 

Q212. - (Topic 6) 

Which item represents the standard IP ACL? 

A. access-list 110 permit ip any any 

B. access-list 50 deny 

C. access list 101 deny tcp any host 

D. access-list 2500 deny tcp any host eq 22 

Answer: B 

Q213. - (Topic 4) 

On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs? 

A. a router with subinterfaces configured on the physical interface that is connected to the switch 

B. a router with an IP address on the physical interface connected to the switch 

C. a switch with an access link that is configured between the switches 

D. a switch with a trunk link that is configured between the switches 

Answer: A 

200-120 test engine

Refresh ccna 200-120:

Q214. - (Topic 5) 

Which two tasks does the Dynamic Host Configuration Protocol perform? (Choose two.) 

A. Set the IP gateway to be used by the network. 

B. Perform host discovery used DHCPDISCOVER message. 

C. Configure IP address parameters from DHCP server to a host. 

D. Provide an easy management of layer 3 devices. 

E. Monitor IP performance using the DHCP server. 

F. Assign and renew IP address from the default pool. 

Answer: C,F 

Q215. DRAG DROP - (Topic 4) 


Q216. DRAG DROP - (Topic 1) 


200-120 actual exam

Exact testking ccna 200-120:

Q217. - (Topic 9) 

Which two statements about IPv6 and routing protocols are true? (Choose two.) 

A. Link-local addresses are used to form routing adjacencies. 

B. OSPFv3 was developed to support IPv6 routing. 

C. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6. 

D. Loopback addresses are used to form routing adjacencies. 

E. EIGRPv3 was developed to support IPv6 routing. 

Answer: A,B 

Q218. - (Topic 1) 

Which of the following statements describe the network shown in the graphic? (Choose two.) 

A. There are two broadcast domains in the network. 

B. There are four broadcast domains in the network. 

C. There are six broadcast domains in the network. 

D. There are four collision domains in the network. 

E. There are five collision domains in the network. 

F. There are seven collision domains in the network. 

Answer: A,F 

Q219. - (Topic 4) 

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table? 

A. the OSPF route 

B. the EIGRP route 

C. the RIPv2 route 

D. all three routes 

E. the OSPF and RIPv2 routes 

Answer: B 

Q220. - (Topic 8) 

At which layer of the OSI model does PPP perform? 

A. Layer 2 

B. Layer 3 

C. Layer 4 

D. Layer 5 

Answer: A 

see more CCNA Cisco Certified Network Associate CCNA (803)