May 2016 updated: test 200-120

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-120 Exam Dumps (PDF & VCE):
Available on: https://www.certleader.com/200-120-dumps.html


Actual of 200-120 vce materials and forum for Cisco certification for IT examinee, Real Success Guaranteed with Updated 200-120 pdf dumps vce Materials. 100% PASS CCNA Cisco Certified Network Associate CCNA (803) exam Today!

2016 May 200-120 Study Guide Questions:

Q181. - (Topic 9) 

Which three characteristics are representative of a link-state routing protocol? (Choose three.) 

A. provides common view of entire topology 

B. exchanges routing tables with neighbors 

C. calculates shortest path 

D. utilizes event-triggered updates 

E. utilizes frequent periodic updates 

Answer: A,C,D 


Q182. DRAG DROP - (Topic 1) 

Answer: 


Q183. - (Topic 2) 

Three switches are connected to one another via trunk ports. Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of VLAN 1? 

A. the switch with the highest MAC address 

B. the switch with the lowest MAC address 

C. the switch with the highest IP address 

D. the switch with the lowest IP address 

Answer: B 


200-120 free download

Improve ccna 640-802 vs 200-120:

Q184. - (Topic 7) 

Which router IOS commands can be used to troubleshoot LAN connectivity problems? (Choose three.) 

A. ping 

B. tracert 

C. ipconfig 

D. show ip route 

E. winipcfg 

F. show interfaces 

Answer: A,D,F 


Q185. - (Topic 8) 

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router. How should the network administrator configure the serial interface of the main office router to make the connection? 

A. Main(config)# interface serial 0/0 Main(config-if)# ip address 172.16.1.1 255.255.255.252 Main(config-if)# no shut 

B. Main(config)# interface serial 0/0 Main(config-if)# ip address 172.16.1.1 255.255.255.252 Main(config-if)# encapsulation ppp Main(config-if)# no shut 

C. Main(config)# interface serial 0/0 Main(config-if)# ip address 172.16.1.1 255.255.255.252 Main(config-if)# encapsulation frame-relay Main(config-if)# authentication chap Main(config-if)# no shut 

D. Main(config)# interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ietf Main(config-if)# no shut 

Answer: B 


Q186. - (Topic 4) 

Refer to the exhibit. 

What can be determined about the router from the console output? 

A. No configuration file was found in NVRAM. 

B. No configuration file was found in flash. 

C. No configuration file was found in the PCMCIA card. 

D. Configuration file is normal and will load in 15 seconds. 

Answer: A 


200-120 brain dumps

100% Guarantee ccna 200-120 dumps:

Q187. - (Topic 4) 

Refer to the exhibit. 

The technician wants to upload a new IOS in the router while keeping the existing IOS. What is the maximum size of an IOS file that could be loaded if the original IOS is also kept in flash? 

A. 3 MB 

B. 4 MB 

C. 5 MB 

D. 7 MB 

E. 8 MB 

Answer: B 


Q188. - (Topic 1) 

For what two purposes does the Ethernet protocol use physical addresses? (Choose two.) 

A. to uniquely identify devices at Layer 2 

B. to allow communication with devices on a different network 

C. to differentiate a Layer 2 frame from a Layer 3 packet 

D. to establish a priority system to determine which device gets to transmit first 

E. to allow communication between different devices on the same network 

F. to allow detection of a remote device when its physical address is unknown 

Answer: A,E 


Q189. - (Topic 9) 

Which condition indicates that service password-encryption is enabled? 

A. The local username password is encrypted in the configuration. 

B. The enable secret is encrypted in the configuration. 

C. The local username password is in clear text in the configuration. 

D. The enable secret is in clear text in the configuration. 

Answer: A 


Q190. - (Topic 5) 

In a GLBP network, who is responsible for the ARP request? 

A. AVF 

B. AVG 

C. Active Router 

D. Standby Router 

Answer: B 



see more CCNA Cisco Certified Network Associate CCNA (803)